 |
How will you test the servo I send you?
Every
servo device is tested both statically and dynamically to
insure proper operation. Encoders, resolvers and tachometers
are adjusted to the correct timing, waveform shape,
offset position, voltage level, etc. Every effort is
made to reduce stray electrical noise to the lowest
possible level, if not eliminate it completely. Electrical
parts are tested for high voltage leaks, shorts, grounds
and overall physical condition. Servo motors are tested for
vibration, current draw, back EMF, torque, temperature
rise, shaft runout, keyway condition, balance, acceleration
rate, magnetic field strength, magnet position and mechanical
integrity, brush spring pressure, correct brush compound,
etc. On low inertia motors, start/stop ramps are tested
to verify acceleration capabilities. Completed servo motors
are run-in for 24 hours (except emergency rebuilds).
Return to the FAQ Page
| ©2001
A-1 Servomotor Repair | sitemap
| servo motor repair
|
